Installing Rubber Parking Stops on Asphalt

Installing a rubber parking curb is a relatively simple process and only requires simple tools to accomplish. Heavy machinery or specialty tools are not required.

You’ll need a broom to prepare the area, a Hammer drill with a 1/2” masonry bit, and a mallet or sledge hammer. To ensure the safety of the installers, you’ll also want to have traffic cones and/or signs on hand as well.

Begin by using the traffic cones or signs available to block off the area in which they’ll be working. This can be done one parking spot at a time, or several if installing multiple locations. Also, keep in mind that installation will not be impaired by inclement weather. Rubber parking curbs are not subjectable to rain or snow. So provided your workers are willing to work in the rain, so is a rubber parking curb!

After you’ve partitioned off your working area, you’ll want to use the broom to remove any dust and debris from the area. This will ensure a solid installation. If debris such as stones or rubbish is left under the curb, this will cause them to sit unevenly and performance will be decreased.

Your site is now prepared for the actual installation. Begin by positioning the parking curb within the parking area. Remember, rubber parking curbs are flexible, so if your surface isn’t perfectly level or flat, it’s okay. Just be sure the curb location is correct.

Place the drill bit within each anchor point hole of the curb. You’ll want to drill approximately 3 – 4″ deep. This is a pilot hole for the anchors you’ll be installing later. If the curb begins to move around while you’re drilling, you can use your foot to steady the curb as you drill.

Once each of the holes are drilled, move the curb and clean the drill shavings from beneath. If necessary, re-drill holes to ensure they are adequate for the rebar spikes used to anchor the curbs.

You can now place the curb back into position and place the 1/2″ rebar spikes (14″ length) in each anchor point location. Use a sledge hammer or mallet to drive the spikes into the asphalt. Be sure to drive the spike to the point that the head of the spike is countersunk into the provided area. This will ensure that the spike is not exposed, and therefore will protect the undercarriage of any low vehicles that may use the parking area.

That’s it! With minor maintenance these parking curbs will provide your customers with protection, and your parking area with a clean, professional look for years to come.